Plain bearings. Tolerances - Tolerances on form and position and surface roughness for shafts and thrust collars Ingestion-build-63114 The information model contains both

The information model contains both data and metadata about that data

Unprotected area

BS EN 12953 specifies requirements for inspection during and after construction

They can be found in HD 605

Part 3 of BS EN ISO 22442 does not consider the effect of any method of elimination and/or inactivation on the suitability of the medical device for its intended use

Plain bearings. Tolerances - Tolerances on form and position and surface roughness for shafts and thrust collars Ingestion-build-63114 The information model contains bothWhat is this standard about? This document specifies tolerances on form and position as well as the surface roughness of shafts, flanges and thrust collars as used in plain bearing units. It is applicable to journal or thrust plain bearing units or to a combination of both, installed either horizontally or vertically. This document is not applicable to crankshaft bearing units in combustion engines.